To figure out whether or not your wood floors are done with a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is run your hand on top of the wood. If you can atmosphere the texture of the grain, the B And Q Kitchen Flooring has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, poisoned with additives for drying) topped with wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, with polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the B And Q Kitchen Flooring is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after practically 10 to 15 minutes, the floors are strong with wax. To remove the white spots, use a piece of fine steel wool lightly dampened with wax and massage gently. The last is if you suspect a varnish or shellac, receive a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been strong with one of the older feat methods, it will flake off.