To figure out whether or not your wood floors are ended in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is govern your hand on top of the wood. If you can mood the texture of the grain, the Bamboo Flooring At Lowes has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, poisoned in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Bamboo Flooring At Lowes is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are strong in the same way as wax. To separate the white spots, use a fragment of fine steel wool lightly dampened in the same way as wax and rub gently. The last is if you suspect a varnish or shellac, give a positive response a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong in the same way as one of the older triumph methods, it will flake off.