To figure out whether or not your wood floors are over and done with subsequent to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is control your hand higher than the wood. If you can quality the texture of the grain, the Bamboo Flooring From Lumber Liquidators has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, unclean subsequent to additives for drying) topped subsequent to wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, subsequent to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Bamboo Flooring From Lumber Liquidators is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are strong subsequent to wax. To remove the white spots, use a fragment of good steel wool lightly dampened subsequent to wax and rub gently. The last is if you suspect a varnish or shellac, admit a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been strong subsequent to one of the older achievement methods, it will flake off.