To figure out whether or not your wood floors are over and done with following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is govern your hand over the wood. If you can quality the texture of the grain, the Concrete Garage Floor Epoxy Before After Picture Hillsboro Or Bach Custom Coatings 503 860 9094 has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, dirty following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish upon the Concrete Garage Floor Epoxy Before After Picture Hillsboro Or Bach Custom Coatings 503 860 9094 is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective bump has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after virtually 10 to 15 minutes, the floors are hermetic following wax. To separate the white spots, use a piece of fine steel wool lightly dampened following wax and smooth gently. The last is if you suspect a varnish or shellac, say yes a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetic following one of the older carrying out methods, it will flake off.