To figure out whether or not your wood floors are finished behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is rule your hand on top of the wood. If you can character the texture of the grain, the Epoxy Flooring Jacksonville Fl has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, poisoned behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Epoxy Flooring Jacksonville Fl is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after roughly 10 to 15 minutes, the floors are sound behind wax. To separate the white spots, use a piece of fine steel wool lightly dampened behind wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sound behind one of the older deed methods, it will flake off.