To figure out whether or not your wood floors are over and done with in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is direct your hand on top of the wood. If you can environment the texture of the grain, the Epoxy Flooring Noblesville has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, infected in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Epoxy Flooring Noblesville is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are solid in the manner of wax. To separate the white spots, use a piece of good steel wool lightly dampened in the manner of wax and massage gently. The last is if you suspect a varnish or shellac, receive a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been solid in the manner of one of the older achievement methods, it will flake off.