To figure out whether or not your wood floors are finished in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is govern your hand higher than the wood. If you can character the texture of the grain, the Epoxy Flooring Over Tiles has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, polluted in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish upon the Epoxy Flooring Over Tiles is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after roughly 10 to 15 minutes, the floors are unassailable in imitation of wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened in imitation of wax and massage gently. The last is if you suspect a varnish or shellac, assume a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable in imitation of one of the older attainment methods, it will flake off.