To figure out whether or not your wood floors are finished bearing in mind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion middle suggests these tests: First is manage your hand more than the wood. If you can vibes the texture of the grain, the Epoxy Flooring Over Wood has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, poisoned bearing in mind additives for drying) topped bearing in mind wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, bearing in mind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Epoxy Flooring Over Wood is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after virtually 10 to 15 minutes, the floors are hermetically sealed bearing in mind wax. To remove the white spots, use a fragment of fine steel wool lightly dampened bearing in mind wax and smooth gently. The last is if you suspect a varnish or shellac, say yes a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed bearing in mind one of the older triumph methods, it will flake off.