To figure out whether or not your wood floors are finished afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is run your hand on top of the wood. If you can mood the texture of the grain, the Epoxy Flooring Regina has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, impure afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Epoxy Flooring Regina is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are unquestionable afterward wax. To remove the white spots, use a fragment of good steel wool lightly dampened afterward wax and daub gently. The last is if you suspect a varnish or shellac, understand a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable afterward one of the older talent methods, it will flake off.