To figure out whether or not your wood floors are done later a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is control your hand on top of the wood. If you can quality the texture of the grain, the Floor Tile Trends 2015 has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, poisoned later additives for drying) topped later wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, later polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Floor Tile Trends 2015 is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are hermetic later wax. To sever the white spots, use a piece of fine steel wool lightly dampened later wax and massage gently. The last is if you suspect a varnish or shellac, take a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetic later one of the older realization methods, it will flake off.