To figure out whether or not your wood floors are over and done with later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is rule your hand exceeding the wood. If you can air the texture of the grain, the Garage Flooring Atlanta has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, impure later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Garage Flooring Atlanta is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after virtually 10 to 15 minutes, the floors are hermetic later than wax. To cut off the white spots, use a fragment of good steel wool lightly dampened later than wax and smooth gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been hermetic later than one of the older execution methods, it will flake off.