To figure out whether or not your wood floors are ended in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is govern your hand over the wood. If you can environment the texture of the grain, the Garage Flooring Austin has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, contaminated in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the Garage Flooring Austin is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetically sealed in the manner of wax. To cut off the white spots, use a fragment of good steel wool lightly dampened in the manner of wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed in the manner of one of the older capability methods, it will flake off.