To figure out whether or not your wood floors are over and done with later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is govern your hand beyond the wood. If you can setting the texture of the grain, the Garage Flooring Edmonton has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, polluted later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Garage Flooring Edmonton is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are solid later than wax. To remove the white spots, use a fragment of fine steel wool lightly dampened later than wax and smooth gently. The last is if you suspect a varnish or shellac, take a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid later than one of the older deed methods, it will flake off.