To figure out whether or not your wood floors are over and done with next a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is rule your hand higher than the wood. If you can mood the texture of the grain, the Garage Flooring Experts Chicago has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, impure next additives for drying) topped next wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, next polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Garage Flooring Experts Chicago is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after about 10 to 15 minutes, the floors are strong next wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened next wax and daub gently. The last is if you suspect a varnish or shellac, believe a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been strong next one of the older realization methods, it will flake off.