To figure out whether or not your wood floors are finished considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is direct your hand greater than the wood. If you can feel the texture of the grain, the Garage Flooring Gold Coast has a penetrating finish (usually a assimilation of a natural oil, such as linseed or tung oil, infected considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Garage Flooring Gold Coast is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are sealed considering wax. To surgically remove the white spots, use a fragment of fine steel wool lightly dampened considering wax and smear gently. The last is if you suspect a varnish or shellac, put up with a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been sealed considering one of the older deed methods, it will flake off.