To figure out whether or not your wood floors are the end considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is run your hand higher than the wood. If you can quality the texture of the grain, the Garage Flooring Hampshire has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, dirty considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Garage Flooring Hampshire is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accumulation has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are sealed considering wax. To remove the white spots, use a piece of good steel wool lightly dampened considering wax and massage gently. The last is if you suspect a varnish or shellac, understand a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed considering one of the older success methods, it will flake off.