To figure out whether or not your wood floors are curtains in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is control your hand greater than the wood. If you can tone the texture of the grain, the Garage Flooring Pros Dallas has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, mixed in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Garage Flooring Pros Dallas is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are hermetically sealed in the manner of wax. To remove the white spots, use a piece of fine steel wool lightly dampened in the manner of wax and massage gently. The last is if you suspect a varnish or shellac, tolerate a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed in the manner of one of the older carrying out methods, it will flake off.