To figure out whether or not your wood floors are done similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is control your hand higher than the wood. If you can character the texture of the grain, the Garage Flooring San Diego has a penetrating finish (usually a captivation of a natural oil, such as linseed or tung oil, polluted similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish upon the Garage Flooring San Diego is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are unquestionable similar to wax. To separate the white spots, use a piece of fine steel wool lightly dampened similar to wax and daub gently. The last is if you suspect a varnish or shellac, say yes a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unquestionable similar to one of the older realization methods, it will flake off.