To figure out whether or not your wood floors are done considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is direct your hand higher than the wood. If you can environment the texture of the grain, the Garage Flooring Seattle has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, polluted considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Garage Flooring Seattle is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are hermetic considering wax. To remove the white spots, use a fragment of fine steel wool lightly dampened considering wax and massage gently. The last is if you suspect a varnish or shellac, allow a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetic considering one of the older feat methods, it will flake off.