To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is rule your hand higher than the wood. If you can setting the texture of the grain, the Garage Flooring Tiles Home Depot has a penetrating finish (usually a amalgamation of a natural oil, such as linseed or tung oil, polluted gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Garage Flooring Tiles Home Depot is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetically sealed gone wax. To sever the white spots, use a fragment of good steel wool lightly dampened gone wax and rub gently. The last is if you suspect a varnish or shellac, agree to a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed gone one of the older feat methods, it will flake off.