To figure out whether or not your wood floors are done in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion middle suggests these tests: First is run your hand exceeding the wood. If you can mood the texture of the grain, the Garage Flooring Vancouver has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, impure in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Garage Flooring Vancouver is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are solid in the manner of wax. To remove the white spots, use a fragment of good steel wool lightly dampened in the manner of wax and massage gently. The last is if you suspect a varnish or shellac, acknowledge a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid in the manner of one of the older expertise methods, it will flake off.