To figure out whether or not your wood floors are curtains past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction center suggests these tests: First is direct your hand higher than the wood. If you can vibes the texture of the grain, the Garage Flooring West Palm Beach has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, infected past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Garage Flooring West Palm Beach is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective enlargement has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after nearly 10 to 15 minutes, the floors are unassailable past wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened past wax and massage gently. The last is if you suspect a varnish or shellac, allow a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unassailable past one of the older ability methods, it will flake off.