To figure out whether or not your wood floors are ended following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is control your hand over the wood. If you can atmosphere the texture of the grain, the Garage Flooring Winnipeg has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, mixed following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Garage Flooring Winnipeg is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after about 10 to 15 minutes, the floors are sealed following wax. To remove the white spots, use a fragment of fine steel wool lightly dampened following wax and massage gently. The last is if you suspect a varnish or shellac, say yes a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed following one of the older talent methods, it will flake off.