To figure out whether or not your wood floors are finished gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel center suggests these tests: First is direct your hand beyond the wood. If you can setting the texture of the grain, the House Floor Plan Editor has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, contaminated gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the House Floor Plan Editor is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after roughly 10 to 15 minutes, the floors are sealed gone wax. To separate the white spots, use a piece of fine steel wool lightly dampened gone wax and rub gently. The last is if you suspect a varnish or shellac, receive a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed gone one of the older realization methods, it will flake off.