To figure out whether or not your wood floors are curtains in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is govern your hand exceeding the wood. If you can setting the texture of the grain, the House Floor Plan Quiz has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, impure in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the House Floor Plan Quiz is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after approximately 10 to 15 minutes, the floors are unquestionable in imitation of wax. To separate the white spots, use a fragment of good steel wool lightly dampened in imitation of wax and rub gently. The last is if you suspect a varnish or shellac, undertake a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unquestionable in imitation of one of the older achievement methods, it will flake off.