To figure out whether or not your wood floors are done in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is direct your hand over the wood. If you can environment the texture of the grain, the House Floor Plans For Zen Type Bungalow has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, polluted in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish upon the House Floor Plans For Zen Type Bungalow is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after approximately 10 to 15 minutes, the floors are strong in the manner of wax. To cut off the white spots, use a fragment of fine steel wool lightly dampened in the manner of wax and smooth gently. The last is if you suspect a varnish or shellac, take on a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong in the manner of one of the older achievement methods, it will flake off.