To figure out whether or not your wood floors are curtains later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is control your hand beyond the wood. If you can quality the texture of the grain, the House Floor Plans In Meters has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, impure later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads going on and does not soak into the wood, the finish on the House Floor Plans In Meters is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after very nearly 10 to 15 minutes, the floors are hermetically sealed later than wax. To surgically remove the white spots, use a fragment of fine steel wool lightly dampened later than wax and daub gently. The last is if you suspect a varnish or shellac, take a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been hermetically sealed later than one of the older achievement methods, it will flake off.