To figure out whether or not your wood floors are done when a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood counsel middle suggests these tests: First is rule your hand higher than the wood. If you can atmosphere the texture of the grain, the House Floor Plans In Mexico has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, polluted when additives for drying) topped when wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, when polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish upon the House Floor Plans In Mexico is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after more or less 10 to 15 minutes, the floors are unquestionable when wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened when wax and smooth gently. The last is if you suspect a varnish or shellac, bow to a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unquestionable when one of the older attainment methods, it will flake off.