To figure out whether or not your wood floors are done afterward a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation center suggests these tests: First is run your hand higher than the wood. If you can quality the texture of the grain, the House Floor Plans Jack And Jill Bathroom has a penetrating finish (usually a engagement of a natural oil, such as linseed or tung oil, polluted afterward additives for drying) topped afterward wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, afterward polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the House Floor Plans Jack And Jill Bathroom is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are sound afterward wax. To cut off the white spots, use a fragment of good steel wool lightly dampened afterward wax and massage gently. The last is if you suspect a varnish or shellac, bow to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sound afterward one of the older realization methods, it will flake off.