To figure out whether or not your wood floors are finished behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion middle suggests these tests: First is manage your hand over the wood. If you can vibes the texture of the grain, the House Floor Plans Newfoundland has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, polluted behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the House Floor Plans Newfoundland is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after roughly 10 to 15 minutes, the floors are hermetic behind wax. To cut off the white spots, use a piece of fine steel wool lightly dampened behind wax and massage gently. The last is if you suspect a varnish or shellac, understand a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been hermetic behind one of the older success methods, it will flake off.