To figure out whether or not your wood floors are ended following a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance middle suggests these tests: First is direct your hand over the wood. If you can air the texture of the grain, the House Floor Plans Over 5000 Sq Ft has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, impure following additives for drying) topped following wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, following polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads up and does not soak into the wood, the finish on the House Floor Plans Over 5000 Sq Ft is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after not quite 10 to 15 minutes, the floors are unquestionable following wax. To sever the white spots, use a fragment of good steel wool lightly dampened following wax and smooth gently. The last is if you suspect a varnish or shellac, take a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been unquestionable following one of the older talent methods, it will flake off.