To figure out whether or not your wood floors are done behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood suggestion center suggests these tests: First is control your hand exceeding the wood. If you can tone the texture of the grain, the House Floor Plans Rear Entry Garage has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, unclean behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the House Floor Plans Rear Entry Garage is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after approximately 10 to 15 minutes, the floors are unquestionable behind wax. To surgically remove the white spots, use a piece of good steel wool lightly dampened behind wax and smear gently. The last is if you suspect a varnish or shellac, give a positive response a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been unquestionable behind one of the older talent methods, it will flake off.