To figure out whether or not your wood floors are the end considering a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is run your hand more than the wood. If you can atmosphere the texture of the grain, the House Floor Plans Rochester Ny has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, tainted considering additives for drying) topped considering wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, considering polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the House Floor Plans Rochester Ny is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after very nearly 10 to 15 minutes, the floors are solid considering wax. To sever the white spots, use a piece of good steel wool lightly dampened considering wax and rub gently. The last is if you suspect a varnish or shellac, resign yourself to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been solid considering one of the older expertise methods, it will flake off.