To figure out whether or not your wood floors are the end in the same way as a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is run your hand over the wood. If you can air the texture of the grain, the House Floor Plans Tanzania has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, impure in the same way as additives for drying) topped in the same way as wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, in the same way as polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the House Floor Plans Tanzania is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after virtually 10 to 15 minutes, the floors are strong in the same way as wax. To cut off the white spots, use a piece of good steel wool lightly dampened in the same way as wax and smooth gently. The last is if you suspect a varnish or shellac, agree to a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong in the same way as one of the older achievement methods, it will flake off.