To figure out whether or not your wood floors are finished taking into account a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance center suggests these tests: First is run your hand on top of the wood. If you can setting the texture of the grain, the House Floor Plans Thailand has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, impure taking into account additives for drying) topped taking into account wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, taking into account polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the House Floor Plans Thailand is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after about 10 to 15 minutes, the floors are strong taking into account wax. To surgically remove the white spots, use a fragment of fine steel wool lightly dampened taking into account wax and massage gently. The last is if you suspect a varnish or shellac, endure a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been strong taking into account one of the older triumph methods, it will flake off.