To figure out whether or not your wood floors are ended in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood instruction middle suggests these tests: First is rule your hand exceeding the wood. If you can mood the texture of the grain, the House Floor Plans Under 1200 Sq Ft has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, contaminated in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab upon a tiny paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish upon the House Floor Plans Under 1200 Sq Ft is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective deposit has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after virtually 10 to 15 minutes, the floors are strong in imitation of wax. To remove the white spots, use a fragment of good steel wool lightly dampened in imitation of wax and rub gently. The last is if you suspect a varnish or shellac, give a positive response a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been strong in imitation of one of the older feat methods, it will flake off.