To figure out whether or not your wood floors are ended behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is manage your hand higher than the wood. If you can feel the texture of the grain, the House Floor Plans Vancouver has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, mixed behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the House Floor Plans Vancouver is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after nearly 10 to 15 minutes, the floors are sealed behind wax. To separate the white spots, use a fragment of good steel wool lightly dampened behind wax and smooth gently. The last is if you suspect a varnish or shellac, bow to a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sealed behind one of the older triumph methods, it will flake off.