To figure out whether or not your wood floors are done like a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is direct your hand greater than the wood. If you can mood the texture of the grain, the House Floor Plans Visio has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, unclean like additives for drying) topped like wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, like polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the House Floor Plans Visio is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after not quite 10 to 15 minutes, the floors are sound like wax. To remove the white spots, use a fragment of good steel wool lightly dampened like wax and daub gently. The last is if you suspect a varnish or shellac, endure a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound like one of the older feat methods, it will flake off.