To figure out whether or not your wood floors are ended in the manner of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is control your hand higher than the wood. If you can environment the texture of the grain, the House Floor Plans With Inlaw Quarters has a penetrating finish (usually a fascination of a natural oil, such as linseed or tung oil, dirty in the manner of additives for drying) topped in the manner of wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in the manner of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads happening and does not soak into the wood, the finish on the House Floor Plans With Inlaw Quarters is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective lump has worn away. Fourth, if you sprinkle on a few drops of water and white a skin condition form beneath the droplets after approximately 10 to 15 minutes, the floors are solid in the manner of wax. To remove the white spots, use a piece of good steel wool lightly dampened in the manner of wax and rub gently. The last is if you suspect a varnish or shellac, say you will a coin and scrape the surface of the floor in an inconspicuous corner. If the floor has been solid in the manner of one of the older capability methods, it will flake off.