To figure out whether or not your wood floors are finished behind a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is rule your hand beyond the wood. If you can tone the texture of the grain, the House Floor Plans With Rv Garage has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, contaminated behind additives for drying) topped behind wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, behind polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the House Floor Plans With Rv Garage is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are strong behind wax. To surgically remove the white spots, use a fragment of good steel wool lightly dampened behind wax and massage gently. The last is if you suspect a varnish or shellac, agree to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been strong behind one of the older triumph methods, it will flake off.