To figure out whether or not your wood floors are finished similar to a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is rule your hand higher than the wood. If you can vibes the texture of the grain, the Jenner House Floor Plans has a penetrating finish (usually a interest of a natural oil, such as linseed or tung oil, polluted similar to additives for drying) topped similar to wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, similar to polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish upon the Jenner House Floor Plans is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after practically 10 to 15 minutes, the floors are strong similar to wax. To remove the white spots, use a fragment of fine steel wool lightly dampened similar to wax and rub gently. The last is if you suspect a varnish or shellac, believe a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been strong similar to one of the older carrying out methods, it will flake off.