To figure out whether or not your wood floors are the end later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance center suggests these tests: First is rule your hand over the wood. If you can tone the texture of the grain, the Kitchen And Flooring Concepts Jacksonville Fl has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, polluted later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Kitchen And Flooring Concepts Jacksonville Fl is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after virtually 10 to 15 minutes, the floors are hermetic later than wax. To sever the white spots, use a piece of fine steel wool lightly dampened later than wax and smear gently. The last is if you suspect a varnish or shellac, receive a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been hermetic later than one of the older expertise methods, it will flake off.