To figure out whether or not your wood floors are done taking into consideration a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is direct your hand more than the wood. If you can character the texture of the grain, the Kitchen Flooring And Fitting has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, impure taking into consideration additives for drying) topped taking into consideration wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, taking into consideration polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads up and does not soak into the wood, the finish upon the Kitchen Flooring And Fitting is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective increase has worn away. Fourth, if you sprinkle upon a few drops of water and white bad skin form beneath the droplets after approximately 10 to 15 minutes, the floors are strong taking into consideration wax. To remove the white spots, use a piece of good steel wool lightly dampened taking into consideration wax and daub gently. The last is if you suspect a varnish or shellac, resign yourself to a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been strong taking into consideration one of the older feat methods, it will flake off.