To figure out whether or not your wood floors are over and done with past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood opinion center suggests these tests: First is rule your hand higher than the wood. If you can feel the texture of the grain, the Kitchen Flooring Glasgow has a penetrating finish (usually a inclusion of a natural oil, such as linseed or tung oil, infected past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads going on and does not soak into the wood, the finish on the Kitchen Flooring Glasgow is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective growth has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after not quite 10 to 15 minutes, the floors are sound past wax. To cut off the white spots, use a fragment of fine steel wool lightly dampened past wax and massage gently. The last is if you suspect a varnish or shellac, understand a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been sound past one of the older completion methods, it will flake off.