To figure out whether or not your wood floors are the end in imitation of a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood guidance middle suggests these tests: First is run your hand exceeding the wood. If you can atmosphere the texture of the grain, the Kitchen Flooring Hillington has a penetrating finish (usually a combination of a natural oil, such as linseed or tung oil, tainted in imitation of additives for drying) topped in imitation of wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, in imitation of polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, area a few drops of water. If the water beads stirring and does not soak into the wood, the finish on the Kitchen Flooring Hillington is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective mass has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are solid in imitation of wax. To sever the white spots, use a fragment of fine steel wool lightly dampened in imitation of wax and smear gently. The last is if you suspect a varnish or shellac, bow to a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been solid in imitation of one of the older exploit methods, it will flake off.