To figure out whether or not your wood floors are done subsequently a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood assistance center suggests these tests: First is control your hand higher than the wood. If you can setting the texture of the grain, the Kitchen Flooring Lumber Liquidators has a penetrating finish (usually a raptness of a natural oil, such as linseed or tung oil, mixed subsequently additives for drying) topped subsequently wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, subsequently polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads in the works and does not soak into the wood, the finish upon the Kitchen Flooring Lumber Liquidators is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective buildup has worn away. Fourth, if you sprinkle upon a few drops of water and white a skin condition form beneath the droplets after virtually 10 to 15 minutes, the floors are unquestionable subsequently wax. To cut off the white spots, use a piece of good steel wool lightly dampened subsequently wax and daub gently. The last is if you suspect a varnish or shellac, recognize a coin and scuff the surface of the floor in an inconspicuous corner. If the floor has been unquestionable subsequently one of the older exploit methods, it will flake off.