To figure out whether or not your wood floors are done past a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information middle suggests these tests: First is control your hand higher than the wood. If you can tone the texture of the grain, the Kitchen Flooring Next To Hardwood has a penetrating finish (usually a immersion of a natural oil, such as linseed or tung oil, polluted past additives for drying) topped past wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, past polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads happening and does not soak into the wood, the finish on the Kitchen Flooring Next To Hardwood is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective layer has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after virtually 10 to 15 minutes, the floors are solid past wax. To separate the white spots, use a fragment of good steel wool lightly dampened past wax and daub gently. The last is if you suspect a varnish or shellac, allow a coin and graze the surface of the floor in an inconspicuous corner. If the floor has been solid past one of the older achievement methods, it will flake off.