To figure out whether or not your wood floors are ended taking into consideration a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is control your hand beyond the wood. If you can tone the texture of the grain, the Kitchen Flooring Options Nz has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, polluted taking into consideration additives for drying) topped taking into consideration wax. Second, in an out-of-the-way spot, dab on a tiny paint remover. If the finish bubbles up, it is a surface finish, taking into consideration polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads taking place and does not soak into the wood, the finish on the Kitchen Flooring Options Nz is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle on a few drops of water and white bad skin form beneath the droplets after just about 10 to 15 minutes, the floors are sealed taking into consideration wax. To remove the white spots, use a fragment of fine steel wool lightly dampened taking into consideration wax and smooth gently. The last is if you suspect a varnish or shellac, put up with a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been sealed taking into consideration one of the older ability methods, it will flake off.