To figure out whether or not your wood floors are ended gone a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood information center suggests these tests: First is manage your hand higher than the wood. If you can character the texture of the grain, the Kitchen Flooring Singapore has a penetrating finish (usually a concentration of a natural oil, such as linseed or tung oil, impure gone additives for drying) topped gone wax. Second, in an out-of-the-way spot, dab on a little paint remover. If the finish bubbles up, it is a surface finish, gone polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads occurring and does not soak into the wood, the finish on the Kitchen Flooring Singapore is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective accrual has worn away. Fourth, if you sprinkle on a few drops of water and white spots form beneath the droplets after nearly 10 to 15 minutes, the floors are sound gone wax. To remove the white spots, use a piece of good steel wool lightly dampened gone wax and daub gently. The last is if you suspect a varnish or shellac, say you will a coin and scratch the surface of the floor in an inconspicuous corner. If the floor has been sound gone one of the older exploit methods, it will flake off.