To figure out whether or not your wood floors are over and done with later than a polyurethane, shellac, wax or varnish, or have a finish that has worn away and is no longer providing coverage, the American Hardwood recommendation middle suggests these tests: First is rule your hand greater than the wood. If you can air the texture of the grain, the Kitchen Flooring Unit Crossword has a penetrating finish (usually a incorporation of a natural oil, such as linseed or tung oil, impure later than additives for drying) topped later than wax. Second, in an out-of-the-way spot, dab upon a little paint remover. If the finish bubbles up, it is a surface finish, later than polyurethane, which coats the floor in a protective layer.
The third is in an out-of-the-way area, place a few drops of water. If the water beads stirring and does not soak into the wood, the finish upon the Kitchen Flooring Unit Crossword is intact. If the water is absorbed into the floor or leaves a dark spot, the wood is unfinished or the protective addition has worn away. Fourth, if you sprinkle upon a few drops of water and white spots form beneath the droplets after roughly 10 to 15 minutes, the floors are solid later than wax. To cut off the white spots, use a piece of good steel wool lightly dampened later than wax and massage gently. The last is if you suspect a varnish or shellac, receive a coin and cut the surface of the floor in an inconspicuous corner. If the floor has been solid later than one of the older skill methods, it will flake off.